it looks like the drive pot connections on this drawing need to go like this (at least according to the schematic on pedalpcb): Drive 2+3 should go to the row where Drive 1 is now, so that they connect to the 22k resistor coming off pin 2 of the IC. Drive 1 actually needs to go to pin 1 of the IC, where drive 2 is currently located. Not sure if this is the only problem that needs solved but the drive pot will definitely square up with the schematic this way.
planning to build later tonight or tomorrow, but i did notice that there needs to be a cut at B4. didn't catch any other errors in the layout. will report back after i get a chance to build it.
aaaaand built! everything seems to be working as expected. i built the current layout and added a cut at B4 as i mentioned before. i think it's safe to tag it. thanks, anders!
Built this one and it doesn't seem to work. Triple checked everything. I'll go through the schematic to see what I missed.
ReplyDeleteDrive 3 is missing?
ReplyDeleteit looks like the drive pot connections on this drawing need to go like this (at least according to the schematic on pedalpcb):
DeleteDrive 2+3 should go to the row where Drive 1 is now, so that they connect to the 22k resistor coming off pin 2 of the IC. Drive 1 actually needs to go to pin 1 of the IC, where drive 2 is currently located. Not sure if this is the only problem that needs solved but the drive pot will definitely square up with the schematic this way.
Thanks Chris. I also noticed that "Tea" 1+2 & 3 are reversed. "Tone" 1+2 & 3 are reversed.
Deleteplanning to build later tonight or tomorrow, but i did notice that there needs to be a cut at B4. didn't catch any other errors in the layout. will report back after i get a chance to build it.
ReplyDeleteaaaaand built! everything seems to be working as expected. i built the current layout and added a cut at B4 as i mentioned before. i think it's safe to tag it. thanks, anders!
ReplyDelete