Sweep label has been updated by bow. Data Corruptor - Yeah, I've been looking at that one for a few times. I can't promise anything since it is going to be a huge!
Finished this today. Getting a high pitched feedback when the mids is just past half. I also noticed compared to the original schematic there is a 100nF missing in the power section. IDK if that matters here. I'm ganna try to build another... i'll report back
So i built this again and same thing is happening... when the mids are just past half, high pitch noise just comes in, you can change the frequency of the pitch with the tone and push knobs... haha... is there anything i can provide to help troubleshoot?
ok I swapped the 4.7 to 3.3... i also noticed the input cap on the schematic is 4.7u so i made that swap... and finally can you double check that Sweep 4(should be Sweep 4&5) and Sweep 5&6(should be Sweep 6).. I made all those changes and its working now
@fuzzhead, great work, thank you. You're the only one that had the correct Prince of Tone layout. Would you consider laying out the Morning Glory V4 when you have time?
Would you consider making the EQD Data Corrupter... https://www.pedalpcb.com/docs/PedalPCB-SuperHeterodyneReceiver.pdf
ReplyDeletealso... layout says Sweep 2&2?
ReplyDeleteSweep label has been updated by bow.
DeleteData Corruptor - Yeah, I've been looking at that one for a few times. I can't promise anything since it is going to be a huge!
Finished this today. Getting a high pitched feedback when the mids is just past half. I also noticed compared to the original schematic there is a 100nF missing in the power section. IDK if that matters here. I'm ganna try to build another... i'll report back
ReplyDeleteSo i built this again and same thing is happening... when the mids are just past half, high pitch noise just comes in, you can change the frequency of the pitch with the tone and push knobs... haha... is there anything i can provide to help troubleshoot?
ReplyDeleteI'll take a second look at the schem vs. layout tomorrow...just have so many projects in the air at the moment....
Deleteno worries take your time. :)
DeleteI've been looking over the eq section and the only mistake I could find (so far)is the value of the 4,7k resistor bellow IC2. It should be 3,3k.
Deleteok I swapped the 4.7 to 3.3... i also noticed the input cap on the schematic is 4.7u so i made that swap... and finally can you double check that Sweep 4(should be Sweep 4&5) and Sweep 5&6(should be Sweep 6).. I made all those changes and its working now
DeleteGreat!. Glad you figured it out and got it working. Layout is updated and tagged as verified.
Delete@fuzzhead, great work, thank you. You're the only one that had the correct Prince of Tone layout. Would you consider laying out the Morning Glory V4 when you have time?
ReplyDeleteThanks. For Moonshine V4, you don't happen to have the schematic?
DeleteThe closest thing I can find is Aion's cirulean, which can be built into the V4. https://aionfx.com/app/files/docs/cerulean_documentation.pdf
DeleteThe actual schematic is very elusive for some reason.
Where's the output? Sorry, I'm totally nu with this (sorry my poor english)
ReplyDeleteYour output is an off board connection to lug 2 of your volume pot. There's a note below the layout.
Delete