Well, got it "sounding". Have to check still if working properly. All pots and switches working (dip and momentary), but still have to adjust trimms, as the difference is remarkable from "nearly free of noise" sound to earpiercing squeal.
Anyway there's at least one error in the board.
-Link from P25 to W25 must be removed. Now iC2 pin 10 must connect to IC3 pin 9. In this board is not posible so the only solution is an aerial wire linking these two pins. Hopefully when Anders returns, will correct the board
I've had a version of this circuit saved for probably five years and still haven't gotten around to putting one together.
ReplyDeletePutting this together in the next few days. I count 35 links though?
ReplyDeleteYes, 35 links it is. Updated.
DeleteI should say, the gate is stuck on when the dip switch is on
ReplyDeleteWell, got it "sounding". Have to check still if working properly. All pots and switches working (dip and momentary), but still have to adjust trimms, as the difference is remarkable from "nearly free of noise" sound to earpiercing squeal.
ReplyDeleteAnyway there's at least one error in the board.
-Link from P25 to W25 must be removed. Now iC2 pin 10 must connect to IC3 pin 9. In this board is not posible so the only solution is an aerial wire linking these two pins. Hopefully when Anders returns, will correct the board
No more errors found and working as supposed. Gate trimmer is key to set the LFO as desired. With the previos change, can be tagged.
ReplyDelete