Verified! I just built it and fired it up. I've been looking for a Superfuzz alternative and this may be it.
I'll test it more in the morning (it's too late to crank this thing) but everything is functional. The Fuzz pot seems a bit noisy/grainy...can't tell if it's a bad pot, soldering issue, etc; It works but the sweep seems a bit 'off'. I'll figure it out tomorrow but so far, so good. Thanks for posting this one & great work!!!!!
Built this yesterday, signal is coming through clean. Changed the 2n5089s but didn't fuzz it up. What troubleshooting should I be looking for beyond the normal cold solder, or bridge, or misplaced part? Could my power source be the issue? Just want some ideas! By the way, thanks to everyone on here!
Verified! I just built it and fired it up. I've been looking for a Superfuzz alternative and this may be it.
ReplyDeleteI'll test it more in the morning (it's too late to crank this thing) but everything is functional. The Fuzz pot seems a bit noisy/grainy...can't tell if it's a bad pot, soldering issue, etc; It works but the sweep seems a bit 'off'. I'll figure it out tomorrow but so far, so good. Thanks for posting this one & great work!!!!!
Awesome!
DeleteThanks for verifying!
Built this yesterday, signal is coming through clean. Changed the 2n5089s but didn't fuzz it up. What troubleshooting should I be looking for beyond the normal cold solder, or bridge, or misplaced part?
ReplyDeleteCould my power source be the issue? Just want some ideas!
By the way, thanks to everyone on here!