The originals had two outputs, with one just being the original clean signal out. I read it was just a wire from the input to a second output jack, and not split after the 1st buffer stage, but I don't know.
Hi everyone, I'm very happy to announce that my build works. I omitted link PQ7 and instead connect from P13 (double link) to H13. So no ground connection to Q13. The 10uF capacitor at OP5 is placed at the removed link PQ7. Also i remove the 2,2M resistor and didn't connect the 10uF between pin 9 and 2 of IC2.
Thank you!
ReplyDeleteThe originals had two outputs, with one just being the original clean signal out. I read it was just a wire from the input to a second output jack, and not split after the 1st buffer stage, but I don't know.
ReplyDeleteHi everyone, I'm very happy to announce that my build works. I omitted link PQ7 and instead connect from P13 (double link) to H13. So no ground connection to Q13. The 10uF capacitor at OP5 is placed at the removed link PQ7. Also i remove the 2,2M resistor and didn't connect the 10uF between pin 9 and 2 of IC2.
ReplyDelete