Oh sweet. Didn't notice that PPCB hadn't provided a schematic for the 900 yet btw. I'll try to verify the JPTR if I can, unless you already tried it yourself. I haven't been building as much but I really like JPTR and Fairfield quite a bit.
Hi, I have built the circuit and it seems to work fine. The only issue I have is that the output seems a little low. would you have any suggestions on how I could improve this? Thanks.
I looked for a better schematic but couldn't find one. I gave the one above another look with squinted eyes and saw no obvious errors. I now have a headache, haha. Is the volume below unity or just not as loud as you'd like? I may build one myself.
Built one over the weekend, out of curiosity. I see why magus was drawn to it. Lots of lows. It's a nice Bee Baa. No issues with volume drop. Certainly loud enough. Thanks for the layout.
this is verified 100%. works very nice ( and i am verry happy because i cannot read the schematic! )
ReplyDeleteThanks Magus!
DeleteTagged.
😂
ReplyDeleteCouple sexy ones on FSB
ReplyDeletehttps://docs.pedalpcb.com/project/NeinFuzz-PedalPCB.pdf
https://www.freestompboxes.org/viewtopic.php?t=34251
I have a layout nearly done for the kaleidoscope. Ill send it over when I can proof read it.
DeleteOh sweet. Didn't notice that PPCB hadn't provided a schematic for the 900 yet btw. I'll try to verify the JPTR if I can, unless you already tried it yourself. I haven't been building as much but I really like JPTR and Fairfield quite a bit.
DeleteI haven't built it so I'm be stoked to see if it works out.
DeleteI can't wait for the 900 pcb to land. Fairfield is aces.
Hi, I have built the circuit and it seems to work fine. The only issue I have is that the output seems a little low. would you have any suggestions on how I could improve this? Thanks.
ReplyDeleteI tried to read the schematic as this seems like a nice fuzz but it's too hard to read.
DeleteI looked for a better schematic but couldn't find one. I gave the one above another look with squinted eyes and saw no obvious errors. I now have a headache, haha. Is the volume below unity or just not as loud as you'd like? I may build one myself.
DeleteUsing sockets? Try swapping transistors, also go over the board to make sure there’s no solder bridge between the strips anywhere.
ReplyDeleteBuilt one over the weekend, out of curiosity. I see why magus was drawn to it. Lots of lows. It's a nice Bee Baa. No issues with volume drop. Certainly loud enough. Thanks for the layout.
ReplyDelete